Effects of Process Temperature, Ultrasonic Amplitude and Application Height on Plastic Deformation During Ultrasonic Shot Peening of Al7075-T6: A Thermally Coupled Taguchi-Assisted Finite Element Investigation


Acikgoz C., ERTÜRK A. T.

12th International Conference on Advances in Machinery, Materials Science and Engineering Application, MMSE 2026, Paris, Fransa, 25 - 26 Temmuz 2026, cilt.100, ss.34-40, (Tam Metin Bildiri)

  • Yayın Türü: Bildiri / Tam Metin Bildiri
  • Cilt numarası: 100
  • Doi Numarası: 10.3233/atde261160
  • Basıldığı Şehir: Paris
  • Basıldığı Ülke: Fransa
  • Sayfa Sayıları: ss.34-40
  • Anahtar Kelimeler: AL7075-T6, Johnson-Cook constitutive model, LS-DYNA, Taguchi design, Ultrasonic shot peening, warm USP
  • Kocaeli Üniversitesi Adresli: Evet

Özet

Ultrasonic shot peening (USP) is a technique involving severe surface plastic deformation used to improve fatigue performance through grain refinement, surface hardening, and the generation of compressive residual stresses. Although traditional USP has been extensively studied in the existing literature, it remains unclear how the process temperature interacts with ultrasonic loading parameters in aluminum alloys. In this study, the effects of process temperature (25, 150, and 300 °C), application height (5 and 10 mm), and ultrasonic amplitude (25 and 50 μm) on the maximum equivalent plastic strain (PEEQ) and von Mises stress were investigated. Analyses were performed by combining a thermally coupled LS-DYNA finite element model based on the Johnson-Cook constitutive law with a Taguchi L9 design. The ultrasonic amplitude parameter caused the greatest change in PEEQ, which increased by approximately 3.2 times as the amplitude increased from 25 to 50 μm. Temperature also affected the deformation response, but the relationship was not linear. Under constant amplitude, PEEQ increased by approximately 71% between 25 and 300 °C; however, the highest value was obtained at 150 °C. The findings indicated an interaction between processing temperature and ultrasonic amplitude. Application height, on the other hand, exhibited a consistent inverse effect on plastic deformation. Optimal plastic deformation was governed by the interaction between temperature and ultrasonic amplitude, and T = 150 °C, A = 50 μm, and H = 5 mm were determined as the optimal numerical simulation conditions for future experimental validation.