An Investigation of Wear Behaviors of Different Monel Alloys Produced by Powder Metallurgy

Creative Commons License

Esgin U., ÖZYÜREK D., KAYA H.

5th International Advances in Applied Physics and Materials Science Congress and Exhibition (APMAS), Oludeniz, Türkiye, 16 - 19 Nisan 2015, cilt.1727 identifier identifier

  • Yayın Türü: Bildiri / Tam Metin Bildiri
  • Cilt numarası: 1727
  • Doi Numarası: 10.1063/1.4945963
  • Basıldığı Şehir: Oludeniz
  • Basıldığı Ülke: Türkiye
  • Anahtar Kelimeler: Monel 400, Monel 404, Monel R-405, K-500 alloy, Powder metallurgy, Wear behaviors, PERFORMANCE
  • Kocaeli Üniversitesi Adresli: Evet

Özet

In the present study, wear behaviors of Monel 400, Monel 404, Monel R-405 and Monel K-500 alloys produced by Powder Metallurgy (P/M) method were investigated. These compounds prepared from elemental powders were cold-pressed (600 MPa) and then, sintered at 1150 degrees C for 2 hours and cooled down to the room temperature in furnace environment. Monel alloys produced by the P/M method were characterized through scanning electron microscope (SEM+EDS), X-ray diffraction (XRD), hardness and density measurements. In wear tests, standard pin-on-disk type device was used. Specimens produced within four different Monel Alloys were tested under 1ms(-1) sliding speed, under three different loads (20N, 30N and 40N) and five different sliding distances (400-2000 m). The results show that Monel Alloys have. matrix and that Al0,9Ni4,22 intermetallic phase was formed in the structure. Also, the highest hardness value was measured with the Monel K-500 alloy. In wear tests, the maximum weight loss according to the sliding distance, was observed in Monel 400 and Monel 404 alloys while the minimum weight loss was achieved by the Monel K-500 alloy.