Yavuz H. İ., Koç F. G., Oktay S., Muratal O., Abakay E., Alontseva D., ...Daha Fazla
METALS, cilt.16, sa.11, ss.1-22, 2026 (Scopus)
-
Yayın Türü:
Makale / Tam Makale
-
Cilt numarası:
16
Sayı:
11
-
Basım Tarihi:
2026
-
Doi Numarası:
10.3390/met16111276
-
Dergi Adı:
METALS
-
Derginin Tarandığı İndeksler:
Applied Science & Technology Source, Scopus, Materials Science & Engineering Collection (ProQuest), Technology Collection (ProQuest), Compendex, INSPEC, Directory of Open Access Journals
-
Sayfa Sayıları:
ss.1-22
-
Kocaeli Üniversitesi Adresli:
Evet
Özet
Fe-based coatings containing hard secondary phases are a cost-effective alternative to Co- and Ni-based hardfacings for improving the wear resistance of steel components. A gas-atomized Fe-M(Nb,Mo,Cr)-C-B alloy was consolidated onto AISI 4140 steel by hot pressing at 1050 °C for 30 min under 50 MPa, producing a coating approximately 1 mm thick. X-ray diffraction of the powder and the consolidated coating identified an α-Fe matrix with M7(C,B)3 and M(C,B) secondary phases. The coating-substrate interface was continuous, with a narrow interdiffusion zone. Statistical nanoindentation gave 14.2 ± 4.4 GPa for the coating and 10.5 ± 1.3 GPa for the substrate. Under dry-sliding conditions, the coating exhibited a specific wear rate of (1.5 ± 0.4) × 10−6 mm3 N−1 m−1, approximately 26 times lower than that of AISI 4140 ((3.9 ± 1.9) × 10−5 mm3 N−1 m−1, 20 N, three tests per material), and a lower mean coefficient of friction (0.45 ± 0.06 vs. 0.54 ± 0.10). Worn-surface analysis indicated mild oxidative and micro-abrasive wear of the coating, in contrast to the adhesive-abrasive wear of the substrate. These results make the alloy a promising feedstock for wear-resistant powder-based coatings.